Endorfy Arx 700 Air chassis review

PC Cases and Modding 223 Page 7 of 13 Published by


Product showcase – Interior

Product Showcase - Interior



Typically (in older cases), you’d need to remove the motherboard to install a new cooler. The giant cutout for your cooler’s backplate should make life easier. With the abovementioned solution, you can reach it from both sides without the unpleasant experience of removing your motherboard from the chassis.




There are three rubber grommets on cutouts on the right side of the motherboard.



The case has 7 PCI card slots secured with screws (but it should be thumbscrews, honestly).



There’s about 7 cm for the fan and radiator combination at the front.




At the front, you can see a place for three 140/120 mm fans or install an LCS there, provided it’s nothing more extensive than a 360 mm rad. There are three Stratus 140 mm PWM fans provided.


At the top can see a place for three 120 mm fans (or two 140 mm ones), or you can install an AIO, not more significant than a 360 mm variant. There is one Stratus 140 mm PWM provided.



A 140 mm fan is pre-installed at the back (Stratus 140 mm PWM). You can easily mount a 120 mm AIO in there instead. Also – there’s an option to mount a 120 mm fan at the bottom.

Share this content
Twitter Facebook Reddit WhatsApp Email Print