Gigabyte GeForce GTX 780 Ti WindForce 3X OC review

Graphics cards 1022 Page 9 of 28 Published by


Graphics Card Thermal Imaging measurements (FLIR)

Thermal Imaging Temperature measurements

A new addition towards our reviews will be the inclusion of Forward Looking Infra Red thermal images of hardware. Over the past years we have been trying to figure out what the best possible way is to measure temperatures on hardware. Multiple options are available but the best thing to do is to visualize heat coming from the product or component being tested. The downside of thermal imaging hardware is simple, FLIR camera's with a bit of decent resolution costs up-to 10.000 EUR. Hence we passed on it for a long time.

With a thermal imaging camera a special lens focuses the infrared light emitted by all of the objects in view. This focused light is scanned by a phased array of infrared-detector elements. The detector elements create a very detailed temperature pattern called a thermogram. It only takes about one-thirtieth of a second for the detector array to obtain the temperature information to make the thermogram. This information is obtained from several thousand points in the field of view of the detector array. The thermogram created by the detector elements is translated into electric impulses. The impulses are sent to a signal-processing unit, a circuit board with a dedicated chip that translates the information from the elements into data for the display. The signal-processing unit sends the information to the display, where it appears as various colors depending on the intensity of the infrared emission. The combination of all the impulses from all of the elements creates the image.

Why A Move Towards Thermal Imaging?

A new trend e.g. cheat is that manufacturers are tweaking their products with another offset, meaning that sometimes (and we have seen this only a couple of times) the temperature reported back by monitoring software often was lower then the product in reality is. With thermal imaging this becomes this becomes a thing of the past as we can seek hotspots on the PCB indicating for example GPU but also VRM temperature as well as how heat is distributed throughout a product. We do hope you will enjoy this new technology as it did cost us an arm and a leg to be able to implement it. 


Above you can see the graphics card in IDLE conditions. We position our measure point in the GPU die area at the backside of the PCB. You can see that's excellene, below 30 degrees C.


Once we start to stress the GPU the thermals quickly change. Now we can measure thermals into the 10th of a degree precise really, our thermal camera is calibrated. We reach 75 degrees C on the GPU, which is spot on with what the thermal probes report back to us. Memory runs to roughly 71 Degrees C and the VRM area is located closer to the rear of the card where it is cooler, they run roughly 87 Degrees C. 


Once we zoom in a little with the camera, and now I am happy we bought a higher than average resolution thermal imaging camera, we can pinpoint some very specific measuring points. M2 indicates the GPU area measured from the backside. And yes, the VRM area runs very hot. It didn't have an adverse effect on overclocking or anything though. We'll show you that later.


When we position the thermal camera outwards we can see that the cooler really works well. The hottest point is the actual exhaust and at the top of the card there is some residual PCB heat detected. Overall I am very please with what we see here as it seems to manage and exhaust hot air really well.

Share this content
Twitter Facebook Reddit WhatsApp Email Print