Product showcase – Interior

Product Showcase - Interior

Typically (in older cases), you’d need to take out the motherboard to install a new cooler. The huge cut-out for your cooler’s backplate should make life easier. With the solution mentioned above, you can reach it from both sides without the unpleasant experience of removing your motherboard from the chassis.

 There are two rubber grommets on cut-outs on the right side of the motherboard.

The case has 7 PCI card slots, which are secured with screws, unfortunately not thumbscrews (in default state). 

There's about 7 cm for the combination of the fan and the radiator at the front.

At the front, you can see a place for three 120 mm fans (or two 140 mm ones), or you can install an LCS there, provided that it’s nothing larger than a 360 mm rad. 

The fans that are provided are the ARGB ones. These 120 mm fans have a relatively low number of blades with fairly steep angles, indicating that they’re rather low-pressure products.

A 140 mm fan is pre-installed at the back. It’s powered by a 3-pin cable (that’s fine) or a Molex (well, it’s almost the end of 2021 Deepcool, that’s an obsolete type of cable, especially for the fans). You can easily mount a 140 mm AIO in there instead.