ASUS GeForce GTX 980 Ti Poseidon Review

Graphics cards 1022 Page 34 of 35 Published by


Overclocking The Graphics Card

Overclocking The Graphics Card

As most of you know, with most video cards you can apply a simple series of tricks to boost the overall performance a little. Typically you can tweak on core clock frequencies and voltages.

What Do We Need?
One of the best tools for overclocking Nvidia and AMD videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here

Where Should We Go?

Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it can really be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.

More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 25 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.

All in all... do it at your own risk!

Original This sample Overclocked 
Core Clock: 1002 MHz Core Clock: 1114MHz Core Clock 1277 MHz
Boost Clock: 1076 MHz Boost Clock: 1203MHz Boost Clock: 1493~1518 MHz
Memory Clock: 7012 MHz Memory Clock: 7012MHz Memory Clock: 8000 MHz

With AfterBurner we applied the following settings:

  • Temp Target 85 Degrees C
  • CPU clock +163 MHz (from default 1114 MHz)
  • Mem clock 8 Gbps effective
  • Voltage + 87Mv
At the above settings you will reach just over 1500 MHz on the Dynamic Boost frequency in most scenarios. This can differ per game and application. There are a lot of limiters active these days inside the GPU and driver doing a lot of things. The GPU will continuously be dynamically altered based on voltage and clock frequency to match the power and temperature targets versus the increased core clock.  







For all overclocked games above we have used the very same image quality settings as shown before. Overall, the generic thumb of rule here for a decent tweak and overclock is that performance can gain anywhere from 5 to 20% performance. The end result depends on a lot of variables though, including power limiters, temperature limiters, fill-rate and so on the performance increment can differ per card, brand, heck... even cooling solution and your chassis airflow.


Once overclocked the heat signature of the card normally changes fast to somewhat hotter, but with the cooler in a liquid cooling loop the thermal image is very similar to defaults (non-OC). Always make sure you have good airflow inside your PC so that trapped hot air can get out. 

Share this content
Twitter Facebook Reddit WhatsApp Email Print