Sabrent and Phison's Gen 5 SSDs Push Boundaries to 14,000 MB/s and Beyond

Published by

Click here to post a comment for Sabrent and Phison's Gen 5 SSDs Push Boundaries to 14,000 MB/s and Beyond on our message forum
https://forums.guru3d.com/data/avatars/m/198/198862.jpg
I want one to replace my sabrent 4.0 i just dont want active cooling on it.
data/avatar/default/avatar03.webp
4KQ1T1 is getting better but still only a small fraction of the 2X sequential read gets generation to generation. Due to the latency, 2X for 4KQ1T1 isn't possible but it would be nice to start seeing a bit more uplift. The 870 EVO gets about 50MB/S for 4KQ1T1 so going to 100MB/S for this PCIe gen 5 SSD, we only doubled performance since SATA 600. In that same time we went from 560 MB/S sequential read to over 12,000 MB/S sequential read, which is more than 20 times more performance. If they nail that 14,000 MB/S target, that is 25 times faster than the best SATA 600 drives. Its too bad that Optane was such a mess. Huge potential but impossible to create cheap M.2 versions with large capacity. I hope by the end of PCIe gen 5 we have SSDs that do ~200 MB/S 4KQ1T1.
https://forums.guru3d.com/data/avatars/m/266/266713.jpg
Rumors say there will be a Smart-Home Heating Adaper by SaveThePlanet Inc. so you can leverage the BTU's that thing throws off.
https://forums.guru3d.com/data/avatars/m/56/56686.jpg
nice speeds but heat it put out is amazing too
data/avatar/default/avatar28.webp
heard in level1techs show that they can't go to 14 because no chip can those are "overclocked" results expect more like 12 if not 10 and I wasted my time as the picture already shows that lol