Corsair Launches Hydro H100i Pro w/ Zero RPM mode

Published by

Click here to post a comment for Corsair Launches Hydro H100i Pro w/ Zero RPM mode on our message forum
data/avatar/default/avatar32.webp
Meh, 400 RPM on those maglevs is dead-silent anyway, zero-RPM is just for marketing. The pump will probably make more noise at those speeds.
https://forums.guru3d.com/data/avatars/m/242/242134.jpg
silent? might have been one of the first batch, but they're were clicking away like stupid, even had corsair send me a new one, thinking it had to be defective (seeing its supposed to be silent). i know im picky when it comes to noise (dont want to hear anything from my rig at low load/idle), as its on my desk, but others arent clicking at the same voltage, and even push more air (noiseblocker/noctua) and/or can be had cheaper (actic silent). just a joke, seeing that adding rgb and having a fan profile that goes down to zero V/rpm (at low temps). is all it take to name something pro nowadays... i remember the days when (my) asus board would cut power to case fans based on temps, while now even in manual mode, the minimum limit is around 40-60%, not zero. almost everything is used on a "on demand" basis (ac/heat/lights/power), so why not allow for all fans to stops maybe except for one rear/top exhaust fan when (load and) temps are low...
https://forums.guru3d.com/data/avatars/m/251/251688.jpg
zero noise / zero rpm and zero warranty if your overclocked cpu overheat and burn too 😀
https://forums.guru3d.com/data/avatars/m/242/242134.jpg
except the complete opposite (for the last one). corsair covers ANY component that gets damaged, when their aio fails...
https://forums.guru3d.com/data/avatars/m/105/105985.jpg
I don't know if it was fri13th or what but my water 2.0 pimp kicked the buckert but no leaks the pump must have died was maybe 2 years 4 months. my corsair h100 took out my board but not the chip when it leaked but was a few years ago. that said I like them I have over 10 aio's of different brands hell i put a h100(not too bad on the grind) I had as back up.i love these things so nice to just put the radiator in a bucket of ice and see what she do.block ice is better fill a few plastic containers the size of the rad 4 inches thick a couple of shop towels around the socket/gpu area coolant lines and walla like a cheap ass water chiller does wonders over clocking for short periods of time unless you take more prep for moisture, but thats too ghetto to run more then 2 hours you can have some geeky fun running apps that test that sorta thing I gotta get a new one and just checking prices at bestbuy $140 for the h100i duel.
https://forums.guru3d.com/data/avatars/m/242/242134.jpg
look at the arctic for lower price, or alphacool for quality (non asetek design incl pump)