Club3D launches MST HUB

Published by

Click here to post a comment for Club3D launches MST HUB on our message forum
https://forums.guru3d.com/data/avatars/m/243/243536.jpg
Very nice, i never liked the idea of configuring all the outputs needed for a triple monitor setup, i'd use one of these rather than going through three outputs.
https://forums.guru3d.com/data/avatars/m/87/87717.jpg
so we waited 4 years for a cure to eyefinity vsync issues (mixing DVI & DP ports). now wait for AMD to fix crossfire (else vsync actually solves frametime issues).
https://forums.guru3d.com/data/avatars/m/238/238545.jpg
"and then can split three the signal to three full HD" wut?
https://forums.guru3d.com/data/avatars/m/243/243203.jpg
I can't wait to have this... been waiting a lot of time to a fix to the out sync when using dvi and dp. Hope they send it to Argentina...
https://forums.guru3d.com/data/avatars/m/120/120840.jpg
Arg, so it's DP++ but DP++ just means the port is dual mode, meaning it outputs either DP or HDMI/DVI, but that HDMI/DVI is just a pass through from the card meaning you're still going to be limited to 2 HDMI/DVI devices even when using this hub. Was kind of hoping they'd also release an active hub for HDMI, particularly HDMI 1.4a so we could get our cave system up and running.