Palit GeForce GTX 780 Super Jetstream review

Graphics cards 1047 Page 27 of 28 Published by

teaser

Overclocking The Graphics Card

Overclocking The Graphics Card

As most of you know, with most video cards you can apply a simple series of tricks to boost the overall performance a little. Typically you can tweak on core clock frequencies and voltages.

What do we need?
One of the best tools for overclocking Nvidia and AMD videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here. We used Precision for now though as AB still needed some work at the time of writing this article.

Where should we go?
Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.

More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.

All in all... do it at your own risk.

Original This sample Overclocked 
Core Clock: 863MHz Core Clock: 980MHz Core Clock: 1080MHz
Boost Clock: 906MHz Boost Clock: 1033MHz Boost Clock: 1228MHz
Memory Clock: 6008 MHz Memory Clock: 6208 MHz Memory Clock: 6956Hz


To get the tastebuds going here's an example of what you can achive with a tweak or two. We applied:

  • Power Target 106%
  • Priority at Temperature target
  • Temp Target 95 Degrees C
  • CPU clock +100 MHz
  • Mem clock +375 MHz
  • Voltage +37 Mv 

Imageh

With this overclock we have extra performance at our hands, as the boost clock will now render at 1200+ MHz depending on the power and temperature signature. The GPU will continuously be dynamically altered on voltage and clock frequency to match the power and temperature targets versus the increased core clock. Have a peek at the results when overclocked.

 

5456_untitled-1

5457_untitled-2

5458_untitled-3

Untitled-0

For all overclocked games above we have used the very same image quality settings as shown before. Overall we have been able to get another 5% to 10% performance out of the graphics card. 

Share this content
Twitter Facebook Reddit WhatsApp Email Print