Product showcase – interior

Product Showcase - Interior

There is quite a lot of space to route cables, but it’s better to pre-route the EPS one before you secure the motherboard inside. There is also a huge cut-out for your cooling solution’s backplate, which should make installing the CPU cooler much more user-friendly. Rubber grommets are installed on the cable pass-through, and this part is also slightly angled (so it should provide a bit more space for your cables on the other side).

Under the rear 120 mm fan, there are 7 PCI card slots secured with regular screws (which is not good in this budget; you’d expect thumbscrews). You can access them from the back of the chassis after removing the cover.

There is a 180 mm length limit for the PSU because the HDD cage is installed permanently. It’s best to stay below 170 mm (and even 160 mm max for the PSU with modular cables) if you want to use it. The PSU bay has foam pads to prevent vibrations from transferring to the frame.

In fact, it’s a bit of struggle to install a 160 mm PSU with modular cables already attached. Ok, next page, please.