Hardware setup | Power consumption
Installation of any of the AMD Radeon cards is really easy. Once the card is seated into the PC make sure you hook up the monitor and of course any external power connectors like 6 and/or 8-pin PEG power connectors. Preferably get yourself a power supply that has these PCIe PEG connectors native.
Once done, we boot into Windows, install the latest ATI Catalyst drivers and after a reboot all should be working. No further configuration is required or needed unless you like to tweak the settings, for which you can open the Catalyst Control Center.
Let's have a look at how much power draw we measure with this graphics card installed. The methodology: We have a device constantly monitoring the power draw from the PC. We stress the GPU to the max, and the processor as little as possible. The before and after wattage will tell us roughly how much power a graphics card is consuming under load. Mind you, the system wattage is measured at the wall socket side and there are other variables like PSU power efficiency. So this is an estimated value, albeit a very good one. Below, a chart of relative power consumption. Again, the Wattage shown is the card with the GPU(s) stressed 100%, showing only the peak GPU power draw, not the power consumption of the entire PC and not the average gaming power consumption.
Here is our power supply recommendation:
- Radeon RX 5700 - On your average system we recommend a 500 Watt power supply unit.
- Radeon RX 5700 XT - On your average system we recommend a 550 Watt power supply unit.
If you are going to overclock your GPU or processor, then we do recommend you purchase something with some more stamina. Also, at half the PSU load (50% usage) your PSU is the most energy-efficient. There are many good PSUs out there, please do have a look at our many PSU reviews as we have loads of recommended PSUs for you to check out in there. Let's move to the next page where we'll look into GPU heat levels and noise levels coming from this graphics card.