The fittings being at the end, that would put me off in my current case but will work well in smaller cases i think.

pegasus1:

The fittings being at the end, that would put me off in my current case but will work well in smaller cases i think.

Really cool for small builds, but a hard sell for those with an existing setup. A block like this would mean replacing half the hardline in my case, just not enough adjustment built into my loop to allow for it (vs most blocks with inlet/outlet on the side being a drop-in swap).

SamuelL421:

Really cool for small builds, but a hard sell for those with an existing setup. A block like this would mean replacing half the hardline in my case, just not enough adjustment built into my loop to allow for it (vs most blocks with inlet/outlet on the side being a drop-in swap).

Also for more elaborate set ups where a Rad is in a lower compartment as i do, I like the loop going from the lower Rad up to the GPU then GPU up to CPU then CPU up to the upper RAd.

I wonder if the piece at the back with the fittings is swappable. The 3080 FE block had 2 different pieces you could use there. one was configured like what we see in the picture, and one had the ports coming out of the back of the card.