In Win Design 904 Chassis
Click here to post a comment for In Win Design 904 Chassis on our message forum
FULMTL
I do like that hidden front intake, but the rear is just a strange design. The chassis could have been a few inches shorter.
BLEH!
Why wasn't this available a month ago... XD
lmimmfn
With the power of dance.
elpsychodiablo
I would see this Case on a Rig of the Month System.
Vtech
What came to mind is this rear compartment is for accommodate some sort of water-cooling and then there is no big need for outtake fan's just one is enough, but it is a strange design although beauty.
dk_lightning
It does have space for an optical drive, its slides in the bottom front, there is a "hatch" it goes into in the back of that empty space at the front.
As for the power switch.. I cant see it 😛
Captain Oats
Anyone wondering about power sw, look carefully at the right side of USB area. It's visible well on the picture with the back and the side of this case, just under a screw.
DiEgO
Review from chiphell:
http://www.chiphell.com/article-8510-1.html
sykozis
It looks nice....but unless you're building a low-end system it's practically useless. 145mm clearance for CPU cooler? Good luck with using anything but the stock cooler. Most decent tower coolers are too tall to fit.
A3D
It's true that In Win's 904 has only a little less than 5¾" clearance for a cpu cooler and that ain't much for an air cooler, but CPU mag tested the 904 rig and managed to stuff a Zalman Reserator 3 closed loop water cpu cooler in there and reported no problems and good temps. They attached the Reserator's twin radiators to the 904's bottom panel fan mount.
tsunami231
I like it but I seriously am not fan of any cause that has transparent sides And there way to many of those cases
