Product Showcase

Bear in mind that you need to connect two 6-pin PEG PCIe graphics power connectors for this board. The power connectors have been seated along the top side. The PCIe slot can deliver roughly 75 Watts, the two 6-pin connectors are rated at 75W each, so that's a good 225 Watts at your disposal for graphics.

The switch on the left will allow you to configure the fan RPM to either silent or performance mode. It's set to silent at default, which offers exceptional cooling really.

As you can see, the card is equipped with three display connectors, two dual-link DVI connectors and a mini-HDMI (1.4) connector.

The cooler tries to exhaust hot air through the upper mesh but realistically 90% of your heat will be dumped inside the PC though, so please do make sure you have a properly ventilated chassis.

Here we have the backside, the PCB is clean and has an uncomplicated design. Make note of the fact that there are two SLI connectors, that makes triple or 3-way SLI a possibility. Alright, that's it for the photo's, keep in mind that most heat will be dumped inside your PC, get proper ventilation going inside your chassis okay?