Review: NZXT H6 Flow chassis

PC Cases and Modding 225 Page 7 of 13 Published by

teaser

Product showcase – Interior


page7_1.webp

Typically (in older cases), you’d need to remove the motherboard to install a new cooler. The giant cutout for your cooler’s backplate should make life easier. With the abovementioned solution, you can reach it from both sides without the unpleasant experience of removing your motherboard from the chassis.


page7_2.webp

You can see a place at the front-right side for three 120 mm fans (pre-installed).


page7_3.webp

No 120 mm fan is pre-installed at the back. It’s powered by a 3-pin cable (that’s fine), non-RGB. You can easily mount a 120 mm AIO in there instead. 


page7_4.webp

The case has seven PCI card slots secured with screws (no thumbscrews).


page7_5.webp

At the top of the chassis, there’s a place for up to 360 mm radiator (but it should be a thin one) or 3x 120 mm fans/2x 140 mm.


page7_6.webp

On the underside, NZXT has a place for the two 140 mm fans on the floor (and considering the prepared space - 120 mm fans would look odd here).

Page7_7

Share this content
Twitter Facebook Reddit WhatsApp Email Print