EK Full Cover Water Block for NVIDIA GeForce GTX 780 Ti

by Hilbert Hagedoorn on: 11/26/2013 01:16 PM | source: | 0 comment(s)

EK introduces world's first full-cover water cooling solution for the latest (NVA-P2083) design NVIDIA GeForce GTX 780 Ti, GTX 780 as well as GTX Titan series graphics cards. EK-FC780 GTX Ti water block directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC780 GTX Ti water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps.

Base is made of electrolytic copper (bare on nickel-plated - depending on the variant) while the top is made of quality cast acrylic material or POM Acetal (depending on the variant). Screw-in brass standoffs are pre-installed and allow for safe installation procedure. The cooling engine now uses refined, 0.6 mm wide microchannel structure to even further improve the heat transfer while not sacrificing the famous low hydraulic restriction design:

Up to four EK-FC780 GTX Ti series water blocks can be interconnected with EK-FC Terminal which allows for hassle-free piping job. The product is available in five different variants, an aesthetic retention backplate is also available:

EK-FC780 GTX Ti - 91,45€
EK-FC780 GTX Ti - Acetal - 91,45€
EK-FC780 GTX Ti - Nickel - 101,61€
EK-FC780 GTX Ti - Acetal+Nickel - 101,61€
EK-FC780 GTX Ti - Nickel (Original CSQ) - 101,61€
EK-FC780 GTX Ti Backplate - Black - 26,38€

Post New Comment

Click here to post a comment for this news story on the message forum.