EK-FC Titan Z launches Water Block for NVIDIA GeForce GTX Titan Z

by Hilbert Hagedoorn on: 05/28/2014 03:25 PM | source: | 1 comment(s)

EK Water Blocks, Ljubljana-based premium liquid cooling gear manufacturer, is proud to introduce world first Full Cover water block for NVIDIA flagship dual-processor graphics card GeForce GTX Titan Z.

EK-FC Titan Z directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC Titan Z water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps.

Base is made of electrolytic copper (bare on nickel-plated - depending on the variant) while the top is made of quality cast acrylic material or POM Acetal (depending on the variant). Screw-in brass standoffs are pre-installed and allow for safe installation procedure. The cooling engine uses refined 0.7 mm wide microchannel structure to even further improve the heat transfer while not sacrificing the famous low hydraulic restriction design:

EK also encloses a two-slot I/O bracket which replaces the original three-slot in order to make installation of multiple graphics cards easier. Up to four EK-FC Titan Z series water blocks can be interconnected with EK-FC Terminal which allows for hassle-free piping job. The product is available in three different variants, an aesthetic retention backplate is also available:

TheDeeGee
Senior Member

Posts: 8881
Joined: 2010-08-28

#4827585 Posted on: 05/28/2014 04:45 PM

I guess it makes sense to spend another 150 on an already 3000 card

Post New Comment

Click here to post a comment for this news story on the message forum.