EK Offers GeForce GTX TITAN X Water Blocks

Published by

teaser

EK launches Full-Cover water block for NVIDIA reference (NVA-PG600) design GeForce GTX TITAN X graphics card. EK-FC Titan X directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks.



EK-FC Titan X water block features EK unique central inlet split-flow cooling engine design for best possible cooling performance, which was introduced for the first time with the EK-FC980 GTX. Such system also works flawlessly with reversed water flow without adversely affecting the cooling performance. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps.

Base is made of electrolytic copper (bare- or nickel-plated, depending on the variant) while the top is made of either acrylic- or POM Acetal material. Plexi variants also features two pre-drilled slots for 3mm LED diodes. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.


Additionaly the EK-FC Titan X has been engineered to perfectly align with EK-FC980 GTX and older EK-FC780 GTX Ti, thus allowing for trouble-free swap out and upgrade without any changes to the cooling loop.

In order to simplify the search for suitable and compatible water block EK is adding newly released graphics cards and motherboard from various manufacturers to EK Cooling Configurator database and compatible graphics cards are being added to the list on daily basis.

These water blocks are made in Slovenia, Europe and are readily available for purchase through EK Webshop and Partner Reseller Network. An aesthetic retention backplate, which also cools the backside (memory IC and VRM) of the circuit board, is also available for separate purchase and comes in five different finish variants.

The various models are priced roughly 100 EURO and roughly 35 EURO for a matching backplate.


Share this content
Twitter Facebook Reddit WhatsApp Email Print