Computex 2015 Exclusive: AMD Fiji GPU Die Photo + Info
So over at the AMD press-conference the CEO of AMD showed the upcoming Fiji GPU. That definitely is 28nm, as that thing is huge ! We also have seen the Radeon Fury X ourselves, actually even with the cooler removed and I was able to inspect the PCB.
We have talked to several board partners about AMDs upcoming flagship GPU called Fiji, I have been able to see the product, yet for obvious reasons we cannot show a photo of it. I can confirm a thing or so for you guys. The product is as previously stated 4GB with its framebuffer, the GPU die as stated and shown below is 28nm, roughly 52mm2 and thus big, seriously big. You can physically see the four stacks of HBM (stacked) memory btw.
The product will not have DVI anymore, but a selection of DisplayPort x3 and HDMI 2.0 x1. The card seems to have six power phases if I counted right slash fast enough and will have two 8-pin connectors PCIe PEG power connectors. So, the card can draw up to 375 watts. Which is indicative for power consumption.
The Fiji cards will be small in size and get a water-cooler based solution. AMD currently seems to be struggling with performance as they had aimed to be slightly faster than a GTX 980 Ti. The development costs for this GPU are high and apparently it performs around the GeForce GTX 980 Ti, some partners indicated that that the performance might acually be a notch lower. As such AMD is trying to see what they can do driver wise and see if the clock frequencies can be raised a little bit more to compensate for that. Then again, if this GPU already needs liquid cooling then that is indicative of a product that runs rather warm. So I am not sure how much leeway there is left for AMD. Of course, the performance of a GeForce GTX 980 Ti is pretty sweet, so to be in or at that level of performance is nothing to be ashamed about if the product is priced right.
The naming of the product is not yet finalized, but that is rumored to be Radeon Fury X. The card will definitely be announced during E3.
Computex 2015: AMD Launches Carrizo Mobile APUs - 06/03/2015 02:42 AM
AMD today launches their Carrizo based Mobile APUs, the new APU architecture makes use of Excavator CPU cores and up-to eight GCN 1.3 based graphics cores. We havea little preview on carrizo's ar...
Computex 2015: In-Win Going for the Kill - 06/03/2015 01:36 AM
Over at the In-Win booth a lot, seriously a lot of chassis are on display including the 805, 808, 909 and that all new H-tower. More after the break....
Computex 2015: Deep Cool - 06/03/2015 12:26 AM
Deep Cool is also present at Computex, on display their have their latest cooling solutions and chassis....
Computex 2015: Noctua going big and silent - 06/03/2015 12:19 AM
Noctua has a small booth at Computex as we always, and as always we happily drop by to what we consider one the best heatpipe based cooling companies on the globe....
Computex 2015: ASUS doing … everything - 06/02/2015 02:28 PM
It is certainly of the more impressive booths here at Computex, ASUS is going BIG. See more and many photos after the break....
Senior Member
Posts: 1003
Joined: 2006-09-02
Mmmm... 28nm, water cooling, 2 8-pin power adapters, another hot running AMD card.
Senior Member
Posts: 1362
Joined: 2004-12-19
Would REALLY like to see some numbers soon - itching for a new card and with these news I'm starting to lean towards nVidia...
GO AMD and deliver a monster card - surprise the sheit out of us

Senior Member
Posts: 107
Joined: 2013-05-12
Why so much hate toward AMD, are people here got fiji's samples and know about final specs and performances .
Senior Member
Posts: 1362
Joined: 2004-12-19
No but if you read this article, then you will see a couple of let downs (hot card, assumingly under 980Ti performance).
Only so much you can really optimize with good drivers...
Senior Member
Posts: 586
Joined: 2008-06-20
As such AMD is trying to see what they can do driver wise
A-ha-ha-ha-haha! Good luck with that!
And no DVI? Nice one.