ZOTAC GeForce GTX 1050 Ti MINI Review

Graphics cards 1048 Page 32 of 39 Published by

teaser

DX12: FCAT Frame Experience Analysis Rise Of The Tomb Raider

With a benchmark technology called FCAT on the following few pages, we will look into Frame Experience Analysis. With the charts shown we are trying to show you graphics anomalies like stutters and glitches in a plotted chart. Lately there has been a new measurement introduced, latency measurement. Basically it is the opposite of FPS.

  • FPS mostly measures performance, the number of frames rendered per passing second.
  • Frametime AKA Frame Experience recordings mostly measures and exposes anomalies - here we look at how long it takes to render one frame. Measure that chronologically and you can see anomalies like peaks and dips in a plotted chart, indicating something could be off. 
Frame time
in milliseconds
FPS
8.3 120
15 66
20 50
25 40
30 33
50 20
70 14

We have a detailed article (read here) on the new FCAT methodology used, and it also explains why we do not use FRAPS anymore.

Frametime - Basically the time it takes to render one frame can be monitored and tagged with a number, this is latency. One frame can take, say, 17 ms. Higher latency can indicate a slow frame-rate, and weird latency spikes indicate a stutter, jitter, twitches; basically anomalies that are visible on your monitor.

What Do These Measurements Show?

Basically, what these measurements show are anomalies like small glitches and stutters that you can sometimes (and please do read that well, sometimes) see on-screen. Below, I'd like to run through a couple of titles with you. Keep in mind that average FPS matters more than frametime measurements. 

Rise Of The Tomb Raider Frame Experience Analysis


Per

Above, a percentile chart of the first 31 seconds @ 2560x1440 of the benchmark recorded. In this particular chart we plot FPS and place it in relation to percentiles. In green, a GTX 1050 4GB and in red a Radeon RX 470. If you look at the X axis at 50%, this you can consider the average frame-rate (this is the intro scene where Lara walks over the snowy mountain).


Now we move to latency measurements (frame-times). Above, the GeForce 1050 Ti 4GB rendering Rise of the Tomb Raider at 2560x1440. On this 31 second run the graphics card shows two stutters, other than that little is going on. At the end what you see is a scene change, it is not an anomaly.

Plot

So on each benchmark page I will add one extra FCAT result, here you can see the GeForce GTX 1050 Ti 4GB and Radeon RX 470, just a little extra for comparison's sake, placed in an overlay.

Share this content
Twitter Facebook Reddit WhatsApp Email Print