Silicon Power M10 External SSD review

Memory (DDR4/DDR5) and Storage (SSD/NVMe) 367 Page 11 of 13 Published by

teaser

SSD Performance HD Tach 3.0.4.0

HD Tach 3.0.4.0

HD Tach is a physical performance hard drive test that uses a special kernel mode VXD to get maximum accuracy by bypassing the file system.

The HD Tach sequential read test is a little bit different from other benchmarks. Most benchmarks create a file on the hard drive and test within that file. The problem is that modern hard drives use a zone bit recording technique that allows different read speeds depending on where the data is located. Data on the outside of the drive is much faster than data recorded on the inside.

Obviously for SSDs this is not an issue. We reach the advertised performance quite well at roughly 138MB/sec measured.

In addition to sequential read performance, HD Tach tests the drive's random access time. Random access is the true measure of seek speed. Many drives advertise sub 10 millisecond seek speeds, but seek speeds are misleading. Also again, without a physical head that needs moving around, the SSDs are just so fast as they have no mechanical moving parts. Here obviously .. the smaller numberĀ is better, 0.2 ms

Silicon power M10 external SSD

Here's a little test report of HDTach in both a long READ and WRITE sequence as well. Overall read performance is good. Write performance however paints a different picture. We see the controller behave weird once we write sustained heaps and heaps of data.

Share this content
Twitter Facebook Reddit WhatsApp Email Print