Seasonic Arch Q503 chassis + Connect PSU review

PC Cases and Modding 227 Page 8 of 15 Published by

teaser

Product showcase – Interior

Product showcase – Interior

Page8_1

A typical two-chamber structure is present, which creates a lot of space for long graphics cards. The power supply and drive cage move into a chamber on the bottom of the case. Regarding the overall capabilities of this case, you can use a 165 mm CPU cooler, a graphics card up to 380 mm, and it’s possible to install water cooling here as well.

 

Page8_2


 The Seasonic ARCH Q503 supports 360 mm radiators at the front, 280 mm at the top, and 120 mm at the back.

 

Page8_3

You can install fans in the following setups:

  • Front: 120 mm x3 / 140mm x2 (and the 2 x 120 mm are preinstalled)
  • Top: 120/140 mm x2
  • Rear: 120mm x1 (Pre-installed)

Page8_4 

 

The motherboard layout is traditional, and there’s a place for the PSU at the bottom of the chassis. The power supply shroud is heavily perforated at the top so air can be exchanged between the two chambers. There are rubber grommets on cut-outs, except the ones close to the PSU shroud.

 

Page8_5

There is a 7 cm total at the front for the radiator and a fan. Ok, let’s head to the further inspection of the interior, then.

Share this content
Twitter Facebook Reddit WhatsApp Email Print