AMD Radeon R9-290X review

Graphics cards 1048 Page 25 of 32 Published by

teaser

FCAT Frame Experience Analysis Tomb Raider

We will look on the following pages into Frame Experience Analysis with a benchmark technology called FCAT. Basically with the charts shown we are trying to show you graphics anomalies like stutters and glitches in a plotted chart. Lately there has been a new measurement introduced, latency measurements. Basically it is the opposite of FPS.

  • FPS mostly measures performance, the number of frames rendered per passing second.
  • Frametime aka Frame Experience recordings mostly measures and exposes anomalies - here we look at how long it takes to render one frame. Measure that chronologically and you can see anomalies like peaks and dips in a plotted chart, indicating something could be off. 
Frame time
in milliseconds
FPS
8.3 120
15 66
20 50
25 40
30 33
50 20
70 14

We have a detailed article (read here) on the new FCAT methodology used, and it also explains why we do not use FRAPS anymore.

Frametime - Basically the time it takes to render one frame can be monitored and tagged with a number, this is latency. One frame can take say 17ms. Higher latency can indicate a slow framerate, and weird latency spikes indicate a stutter, jitter, twitches basically anomalies that are visible on your monitor.

What Do These Measurements Show?

But basically what these measurements show are anomalies like small glitches and stutters that you can sometimes (and please do read that well, sometimes) see on screen. Below I like to run through a couple of titles with you. Mind you that Average FPS matters more than frametime measurements. It's just an additional page or two of information that from now on we'll be serving you.

Tomb Raider Frame Experience Analysis

Per

Above a percentile chart of the 30 seconds @ 2560x1440. Here we plot FPS and place it in relation to percentiles. This methodology could be used to determine average FPS as well.

Check the 50% marker:

  • R7-260X does roughly 29 FPS on average in this scene sequence
  • GTX 780 does roughly 74 FPS on average in this scene sequence
  • R9-290X does roughly 87 FPS on average in this scene sequence

This is actually spot on with the previous recorded scores. But now lets look at frame latency.

Plot

Above is the card tested at a monitor resolution of 2560x1440 (QHD). You'll notice that here frametime scaling in milliseconds is higher for the slower cards, and lower for the fast cards. Low latency means a graphics card can squeeze more frames into one second. As you can see for all cards tested there are no stutters recorded. This really is as good as it can get. This is nearing perfection.

With this chart, lower = better. Huge spikes above 40ms - 50ms can be considered a problem or indicate a low framerate. Spikes that drop down can be dropped frames.

Share this content
Twitter Facebook Reddit WhatsApp Email Print