Palit GeForce RTX 2070 Dual review

Graphics cards 1048 Page 27 of 30 Published by

teaser

Overclocking The Graphics Card

Overclocking The Graphics Card

As most of you know, with most video cards you can apply a simple series of tricks to boost the overall performance a little. Typically you can tweak the core clock frequencies and voltages. By increasing the frequency of the video card's memory and GPU, we can make the video card increase its calculation clock cycles per second. It sounds hard, but it can really be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.

More advanced users push the frequency often way higher. Usually, when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 25 MHz and leave it at that. Usually, when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it. All in all... you always overclock at your own risk!
  

 
Oc-ab 
Original This sample Overclocked 
Core Clock: 1410 MHz Core Clock: 1350 MHz Core Clock: 1550 MHz
Boost Clock: 1620 MHz Boost Clock: 1665 MHz Boost Clock: ~2000 MHz
Memory Clock: 14000 MHz Memory Clock: 14000 MHz Memory Clock: 16000 MHz

We've prepped a new beta build (download) with AfterBurner that you can use to tweak the card. Both manual an with the new curve based OC scanner (next page). You'll see that most cards out there all will tweak to roughly the same levels due to all kinds of hardware protection kicking in.

We ended up with the following settings:

  • Temp Target 88 Degrees C
  • Power Limiter: 114%
  • CPU clock + 200 MHz
  • Mem clock +1000 MHz 
  • Voltage +100%
  • FAN RPM default

45409_untitled-3

 

45410_untitled-1

 

To the far right where you can see "Aver Difference %", this is the result of the four games tested and averaged out. Manually tweaked we gained 10% seen from reference performance with this tweak.

45408_untitled-2

45407_untitled-1

Oc_spy

Share this content
Twitter Facebook Reddit WhatsApp Email Print