Palit GeForce GTX 560 Sonic Platinum review

Graphics cards 1048 Page 2 of 23 Published by

teaser

Features and specifications

Features and specifications

So before we begin, we need to explain the differences in-between a GTX 560 regular and the GTX 560 Ti editions. Ti will be the more advanced version whereas the regular editions will be a notch slower as one cluster of shader processors (SM) was cut off.

Both products are based on the GF114 GPU whereas the GTX 460 based based on the GF104 GPU, it is tweaked a little though to allow higher clock speeds with presumably a lower power draw.

  • The GeForce GTX 560 Ti has 384 shader processor cores, 32 ROPs, and a 256-bit wide memory interface that connects to four 64-bit controllers each with 256MB memory tied to them.
  • The GeForce GTX 560 has 336 shader processor cores, 32 ROPs, and a 256-bit wide memory interface that connects to four 64-bit controllers each with 256MB memory tied to them.
  • The GeForce GTX 460 has 336 shader processor cores, 32 ROPs, and a 256-bit wide memory interface that connects to four 64-bit controllers each with 256MB memory tied to them.

So with some shader processors disabled, the GTX 560 is spec by spec precisely the same as the GTX 460. But the based on the GF114 GPU, it allows it to be clocked higher, overclocked you might see products even nearing 1 GHz on the graphics core.

The new GPU has holstered a higher GPU clock speed, with 810 MHz core, 1620MHz on the shader cores, and 4008 MHz (GDDR5 effective datarate) memory, churning out a very decent 128 GB/s in memory bandwidth.

Now, most of all this sounds familiar eh? Yeah... remember the GF104 being used in the GeForce GTX 460 series? The new GF114 is in fact based of that IC, yet now with all shader processors enabled.

For the bigger part of the specifications the two feel similar when it comes to shader processor count, memory bus and clock frequencies, the GTX 560 definitely will be a good chunk faster.

Reference specifications:

Graphics card GeForce GTX 460
1024MB
GeForce GTX 560 Ti 1024MB GeForce
GTX 560
Palit
GTX 560
Sonic
Graphics Processing Clusters 2 2 2 2
Streaming Multiprocessors 7 8 7 7
Shader processor 336 384 336 336
Texture Units 56 64 56 56
ROPs 32 32 32 32
Core Clock 675 MHz 822 MHz 810 MHz 900 MHz
Shader Clock 1350 MHz 1644 MHz 1620 MHz 1800 MHz
Memory Data rate 3600 MHz 4008 MHz 4008 MHz 4200 MHz
Graphics Memory 1024MB GDDR5 1024MB GDDR5 1024MB GDDR5 1024MB GDDR5
Memory interface 256-bit 256-bit 256-bit 256-bit
Memory bandwidth 115 GB/s 128 GB/S 128 GB/S 134 GB/S
Fab node 40nm 40nm 40nm 40nm
TDP 160 Watts 170 Watts 150 Watts 160 Watts

If you look closely at the SM (Streaming Multiprocessor) partitions below, then you can see and calculate that a 336 shader processor based GF104 on the GeForce GTX 460 has in fact seven SM partitions. 7 are enabled = 336 Shader processors.

Not the GF114 GPU has 384 shader processors, and has that last available SM cluster enabled for the Ti model, yet what you need to remember is that for the regular GTX 560 only 7 SMs are enabled... thus it has 336 Shader/Cuda/Stream processor units.

GTX400_sdf44.png

The GeForce GTX 560 is based on a 40nm fabrication node, still has 1.95 billion transistors and thus looks and feels like the GTX 460, yet now with 48 shader processors per SM and accompanying PolyMorph Engine added. All cards derived from and based on this GPU will be based on a dual or even triple-slot cooling design based on what the AIB/AIC partners prefer and come with two dual-link DVI and a mini-HDMI connector. HDMI will again pass sound through, including bit streaming support for Dolby True HD and DTS-HD Master.

Being a mid-range product, only 2-way SLI will be allowed and thus you'll only see a single SLI finger/connector on the PCB. Okay, the next stop will be an extensive photo-shoot of today's tested product.

In this article we test the Palit GeForce GTX 560 Sonic Platinum edition.

Share this content
Twitter Facebook Reddit WhatsApp Email Print