OCZ Memory (1 GB) PC3200 (2:2:2:5)

Memory (DDR4/DDR5) and Storage (SSD/NVMe) 367 Page 3 of 8 Published by

teaser

Page 3

Technology and Photo's
Right, OCZ memory. As you already noticed, this product is made for a rather specific category of PC users, tweakers and overclockers. People who tweak the crap out of their system, I like to call them enthusiasts. To be able to test this product to it's fullest potential we will need to overclock the PC and of course we'll do just that. We'll check this product with aggressive BIOS ram timings and a CAS at 2 (Column Address Strobe) latency to see if it lives up to it's specification. In this test we will make use of a test system that allows overclocking and memory tweaking from within the BIOS.

The Module
Let's take a closer look at the memory modules.

Copyright 2005 - Guru3D.com

We received a Dual Channel (paired) kit, 512 MB each.

The module is constructed out of a six layer PCB (Printed Circuit Board). You have to admit, the golden (yet copper) heat spreader is looking fancy. In fact it's one of the more beautiful looking modules out there. The heat spreader is firmly attached to the module but once removed we find Winbond BH memory. A green colored PCB and furthermore what catches the eye is that the module looks very well-built.

Copyright 2005 - Guru3D.com

This module in fact supports a CAS latency of 2 at 2.8v (default, I recommend 2.6 volts though as that was 100% stable also). If you need for example a DDR533 rating you definitely need to increase that voltage to at least 3.5 volts, so check your BIOS before buying. But hey CAS 2:2:2:5 for 400 MHz PC3200 memory, timings do not get faster then that people.

Copyright 2005 - Guru3D.com

As stated, this is a paired (2x512MB) kit for Dual Channel configuration. The older motherboards we have in our rigs these days only offer single-channel DDR266/333/400 support which only delivers half of the memory bandwidth. The Pentium 4 is very sensitive to memory bandwidth. If your mainboard supports Dual Channel, then please go for it.

You know, the best utilization on CPU FSB versus the memory is 1:1. So a 800 MHz FSB versus 800 MHz DDR memory would be ideal. We're not quite there yet I'm afraid.

Copyright 2005 - Guru3D.com

And on the backside of the packaging we see... ;)

Share this content
Twitter Facebook Reddit WhatsApp Email Print