Overclocking The AMD Radeon R9-390X
Overclocking The Graphics Card
As most of you know, with most video cards you can apply a simple series of tricks to boost the overall performance a little. Typically you can tweak on core clock frequencies and voltages.
What Do We Need?
One of the best tools for overclocking Nvidia and AMD videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here.
Where Should We Go?
Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it can really be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz. More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 25 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well.
All in all... do it at your own risk!
| Original | This sample | Overclocked |
| Max Clock: 1050 MHz | Max Clock: 1100 MHz | Max Clock: 1200 MHz |
| Memory Clock: 6000MHz | Memory Clock:6100 MHz | Memory Clock: 6600 MHz |
With tweaking software we applied:
- Power Target +50%
- CPU clock 1200 MHz
- Mem clock 1650/6600 MHz
- Increased fan RPM - 40~45%
This overclock is based on air cooling. Have a peek at the results when overclocked.
For all overclocked games above we have used the very same image quality settings as shown before. Overall the generic rule of thumb here for a decent tweak and overclock is that performance can gain anywhere from 5 to 20%. The end result depends on a lot of variables though, including power limiters, temperature limiters, fill-rate and so on, the performance increment can differ per card, brand, heck... even cooling solution and your chassis airflow.
After overclocking and applying a little extra voltage, the card will definitely run hotter. GPU temps rise towards roughly 80 Degrees C and as you can see from the thermal image, the board runs a bit hotter as well.
