Overclocking & Tweaking
Overclocking The Graphics Card
As most of you know, with most videocards you can apply a simple series of tricks to boost the overall performance a little. You can do this at two levels, namely tweaking by enabling registry or BIOS hacks, or very simply to tamper with Image Quality. And then there is overclocking, which will give you the best possible results by far.
What do we need?One of the best tools for overclocking NVIDIA and ATI videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here.
Where should we go?
Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.
More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.
All in all... do it at your own risk.
We overclock the R7770 as that is the more likable product in the range.
| Original (GHz models) | This sample | Overclocked + VTweak 1250Mv |
| Core Clock: 1000 MHz | Core Clock: 1100 MHz | Core Clock: 1200 MHz |
| Shader Clock: 1000 MHz | Shader Clock: 1100 MHz | Shader Clock: 1200 MHz |
| Memory Clock: 4500 MHz | Memory Clock: 4500 MHz | Memory Clock: 5400 MHz |
Now we need to free the card up from TDP restrictions first, so all the way down move the Power control settings slider towards 20%. So if the max allowed board TDP is 100 Watt x 1.20 = 120W of overclocking headroom.
The PE edition also allows voltage tweaking on GPU. Memory and Auxiliary voltage
Overclocking wise the card will allow itself to be clocked to roughly 1150 MHz on the core easily and that's without additional voltage tweaking. When you grab AfterBurner and apply Voltage tweaking will get you higher. When we applied 1200Mv on the GPU core we reached 1200 MHz -- and that is okay. The GPU was getting warmer as we reached 70 Degrees C.
Above, Crysis 2, same maxed out image quality settings as before yet now with added overclock results:
- DirectX 11
- High Resolution Texture Pack
- Ultra Quality settings
- 4x AA
- Level - Times Square (2 minute custom time demo)
Above, 3DMark 11 - the Performance test and score. As you can see, there is an additional bump in this very GPU limited software, lovely.
Above, Alien versus Predator, in 1920x1200 at 4xAA and 16X anisotropic filtering
