MSI MAG B660M Mortar WIFI review

Mainboards 327 Page 20 of 21 Published by

teaser

VRM Area Thermals

VRM Area Thermals

Lately, it has been requested if we could list VRM temperatures. We could hook into sensors and start measuring. Now a good way really is to look at the VRM area with a thermal camera. This way you can detect hot-spots and/or worrying stuff. We run the FPU and CPU torture test in AIDA. The chart plot shows the maximum VRM temperature measured at thermal sensor level. The VRM temperatures you see listed in the chart are not based upon the thermal image, but the max temp reported by the thermal sensors at the VRM stages. 


Image6ghfcg

AIDA FPU Stress test - Core i5 12400 / MOS/VRM reports back 36 Degrees C max

The thermal image is there for visualization of heat bleed, not measurement as most part of the VRM is covered by heatsinks.

  • System setup: normal conditions / default settings 
  • We stat AIDA FPU Stress test, leave it running for 15 minutes, and note down the highest temperature measured on VRM sensors. If there are two VRM loops, we note down the hottest measured temperature.

With these power stages, heat cannot be an issue.


Flir_20211223t111337

Share this content
Twitter Facebook Reddit WhatsApp Email Print