Lepa G1600 PSU review

PSU - Power Supply Units 108 Page 7 of 8 Published by

teaser

Load testing the PSU with multiple GPUs

Load testing the PSU with multiple GPUs

Well, we do have multiple GeForce GTX 590 cards at our disposal, so why not put some more load on the PSU and enable four GPUs? Since this is a 1600W PSU we could not leave you guys hanging dry. We in fact installed a second GeForce GTX 590 to monitor power draw. You'll notice that four GPUs will stress the power supply more.

 1821_untitled-4

This is merely a demonstration test that shows the total wattage in the different tested Gold and Platinum models. With four GPUs during gaming we peak a 732W power draw, which in all honestly is impressively close to Platinum certified PSUs, which will save you a little extra alright.

Under this load the PSU did get lukewarm and the fan starts to work harder, you can hear the PSU. We had the PSU outside a chassis at this stage though so there was no active airflow.

Stability testing the PSU

So, during our tests we also monitor the voltage fluctuations as shown below in both IDLE and LOAD states of the PC. We write down the lowest and highest value we see within a certain PC state. The difference is the fluctuation. If a PSU is unstable we'd see a lot of fluctuation, differences and discrepancies which can result in system instability.

Untitled-1 

This is old fashioned Digital MultiMeter work. Once we've gathered all Voltage results we can place them in an easy to understand chart. Look at the chart, the two lines show both the Idle and Load state of a specific voltage rail, the dark blue one the lowest voltage dip measured, the red one the highest fluctuation. That's your baseline.

So then, ATX specification requires that the PSU needs to stay within a 5% fluctuation; for example, each +12 Volt rail should remain between 11.4 - 12.6 Volts. 

As you can see, the PSU when utilized stays consistent as you can hardly even see the blue line, meaning that the PSU is functioning within ATX specified limits. Spot on.

Sound levels (dBA)

With a calibrated dBA meter we look for noise pressure coming from the PSU. The human hearing system has different sensitivities at different frequencies. This means that the perception of noise is not at all equal at every frequency. Noise with significant measured levels (in dB) at high or low frequencies will not be as annoying as it would be when its energy is concentrated in the middle frequencies. In other words, the measured noise levels in dB will not reflect the actual human perception of the loudness of the noise. That's why we measure the dBA level. A specific circuit is added to the sound level meter to correct its reading in regard to this concept. This reading is the noise level in dBA. The letter A is added to indicate the correction that was made in the measurement.

As always we measure 75 CM away from the product (usually the distance between you and a desktop computer).

  • As stated, up-to IDLE load (200W) we reach 39 DBa, you can hear the PSU slightly.
  • At ~732W load you can hear the PSU still at 39 DBa, meaning you can hear the PSU slightly,
Unfortunately that is the maximum we can stress this power supply.

All in all the PSU simply remains reasonably silent, but not quiet. So throughout the scope of tests the performance, power draw and noise levels remain very good.

Share this content
Twitter Facebook Reddit WhatsApp Email Print