Product Installation
Product Installation
We are testing the cooler in a case, in order to recreate a real-life scenario.
The RGB cable from the pump goes to the RGB header on the motherboard. Then, there is a 4-pin cable to power up the pump. In our experience, pump control is also possible with it. The maximum pump speed is about 5,000 rpm. We were able to reduce the speed to around 2,400 rpm. The fans need power from 4-pin PWM connectors, and you should have used the provided y-splitter cable for that (but that’s not applicable, unfortunately). Well, there' CPU fan header and CPU_Opt(ional) usually on the motherboards, but that leaves one fan standing.
The pressure of the block is good. The tubing is flexible (and long – 420 mm), and its position can be easily adjusted.
