Overclocking the graphics card

Overclocking the graphics card

Most graphics cards you can apply a simple series of tricks to boost the overall performance a little. Typically you can tweak the core clock frequencies and voltages. By increasing the frequency of the video card's memory and GPU, we can make the video card increase its calculation clock cycles per second. It sounds hard, but it can really be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your GPU runs at 1500 MHz then I suggest that you don't increase the frequency any higher than 25 MHz increments.

More advanced users push the frequency often way higher. Usually, when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 25 MHz and leave it at that. Usually, when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 25 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it. All in all... you always overclock at your own risk.

Reference frequency	This sample	Overclocked
Boost Clock: 1695 MHz	Boost Clock: 1695 MHz	Boost Clock: ~2000MHz
Memory Clock: 19500 MHz	Memory Clock: 19500 MHz	Memory Clock: 20000 MHz

With AfterBurner (download here) you can tweak the card both manually and with the curve based OC scanner. You'll see that most cards out there will all tweak to roughly the same levels due to all kinds of hardware protection kicking in. Memory clocks are double-data-rate thus, say, 9750 Mhz is 19500 Gbps effective.

We applied the following settings in Afterburner:

• Core Voltage +50
• Power Limiter: 114%
• Clock +45 MHz Dynamic GPU clock ~2000 MHz 
• Mem clock +250 (=2.0 GHz effective)
• FAN RPM default

Due to new memory protections, we advise your memory clock at roughly +250 MHz for best results, double-data-rate you're now at 2 GHz. We had quite a bit left on the power limiter, 114%, this will help you boost performance better than higher clock (turbo) frequencies. Of course, that does come at the cost of additional energy consumption. 

The results show respective default clocked results plotted in percentages. To the far right where you can see "Aver Difference %", this is the result of the four games tested and averaged out.