Galax HOF OC Lab Water Cooling 4400 MHz CL19 review

Memory (DDR4/DDR5) and Storage (SSD/NVMe) 367 Page 5 of 22 Published by

teaser

Memory timings – a bit of theory about the basic parameters

Memory timings – a bit of theory about the basic parameters

The general rule is simple – the lower the number, the better the performance. When you look at the specs of a memory kit, for example, the one in this review, you will see something like CL19-19-19-39 1.4V (2T). What does it mean? Well, this refers to CAS-TRCD-TRP-TRAS and CMD. These values are measured in clock cycles.  


Sticker

  • CAS latency (CL) – the number of cycles between sending a column address to the memory and the beginning of the data in response. This is the number of cycles it takes to read the first bit of memory from a DRAM with the correct row already open. Unlike the other numbers, this is not a maximum but an exact number that must agree between the memory controller and the memory.
  • Row Address to Column Address Delay (TRCD) – it’s the minimum number of clock cycles required between opening a row of memory and accessing columns within it. The time to read the first bit of memory from a DRAM without an active row is TRCD + CL.
  • Row Precharge Time (TRP) - the minimum number of clock cycles required between issuing the precharge command and opening the next row. The time to read the first bit of memory from a DRAM with the wrong row open is TRP + TRCD + CL.
  • Row Active Time (TRAS) - the minimum number of clock cycles required between a row active command and issuing the precharge command. This is the time needed to refresh the row internally and overlaps with TRCD. In SDRAM modules, it is simply TRCD + CL. Otherwise, approximately equal to TRCD + 2×CL.

Command Rate (CR) - Now, 1T means it takes one clock cycle to “find” a memory bank, vs. 2T, where it takes two clock cycles to “find” the memory bank. Whether the chip selection can be executed in a single clock or whether it needs two clocks depends on various factors. Among the most contributing factors appears to be the number of banks populated within the system from which the right bank has to be selected. In a single-bank configuration, the system already knows that all data have to be within this bank. If more banks are populated, there is an additional decision involved. 


Page5_2

Determining the optimum timings can be very time-consuming, and it’s a matter of many attempts to achieve stability. Fine-tuning the above settings can bring some nice improvements. Especially Command Rate is commonly underestimated, as you can see in our Ryzen RAM performance article. There are also some further timings, which most users leave for the motherboard to configure automatically. Still, they can be helpful if you’re joining the competition to beat some world records in SuperPi (but I’m not, so I always skip that part). 

Share this content
Twitter Facebook Reddit WhatsApp Email Print