EVGA GeForce GTX 560 Ti 2Win review - Overclocking the graphics card

Overclocking the graphics card

As most of you know, with most videocards you can apply a simple series of tricks to boost the overall performance a little. You can do this at two levels, namely tweaking by enabling registry or BIOS hacks, or very simply to tamper with Image Quality. And then there is overclocking, which will give you the best possible results by far.

What do we need?
One of the best tools for overclocking NVIDIA and ATI videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here.

Where should we go?
Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.

More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.

All in all... do it at your own risk.

Overclocking wise the card will allow itself to be clocked to roughly 900 MHz on the core without additional voltage tweaking. Voltage tweaking itself is not a problem as a pretty default CHIL IC is used, being supported in AfterBurner.  EVGA however is inn final stages with their own Voltage tweak application.

We raised the GPU voltage to 1.1V. And that brings us to a completely stable 940MHz on both GPUs as a result, and that is still very impressive. Increasing the voltage any further would result in the GPU getting slightly warmer as we reached 75 Degrees C. The noise level remained roughly the same though, 42 dBA.

Above, Battlefield 2, same maxed out image quality settings as before with 8xAA 16xAF.

Above, 3DMark 11 - the Performance test and score. As you can see, an additional bump in this very GPU limited title, lovely.

Above, Alien versus Predator, in 1920x1200 at 4xAA and 16X anisotropic filtering