Product Showcase - Exterior

Product Showcase - Exterior

There’s been no revolution on the back, and you can spot seven horizontal expansion slots there (the covers are reusable and have square air vents). So, it’s possible to have dual-slot cards in Crossfire or SLI mode in a traditional horizontal setup.

The PSU bracket is not removable (and it would allow easier PSU installation). There’s a single set of mounting holes, but that should be fine.

You can see a place for the 120/140 mm fan at the back, with a pre-installed 140 mm unit already in place.

You’ll find a standard front I/O panel on the top of the case. The selection is broad while we’re at it, with two USB 3.0 ports (unfortunately no USB 3.1 Type-C port), an audio jack, and two buttons to power your system on/off and make the LED adjustment. This is not a good solution for people who keep their cases on the desk, as reaching the ports might be difficult in a setup like that. Additionally, the buttons are similar, so you may confuse them and turn the system off instead of changing the lighting colour.

The right side panel is held by the thumbscrews, which you can find at the back of the chassis.

The left side panel has the same solution.