Cougar Blazer review

PC Cases and Modding 227 Page 6 of 12 Published by

teaser

Product showcase – interior

Product Showcase - Interior

  

Page6_1


You can install up to three 3.5” drives/five 2.5” ones. Two of them (2.5/3.5”) are mounted on the backside, under the cooler cut-out. One 2.5” drive can be mounted on the metal cable cover. Two drives can also be mounted on the second layer of the front panel. They’re secured with thumbscrews.


Page6_2

 

You can fit big components inside. This case supports graphics cards up to 350 mm in length, and CPU coolers up to 160 mm in height (well, that’s not too impressive). Liquid cooling enthusiasts may appreciate this product, as it’s possible to mount a combo of radiators of up to 360 + 240 mm.


Page6_3

 

The motherboard layout is traditional, and there’s a PSU on the bottom of the chassis. The biggest radiator is mounted on the side, as is usually the case with water-cooling-oriented enclosures.


Page6_4

 

There is a lot of space to route cables (there are no rubber grommets, of course), including the EPS one, which can be tricky in some other chassis, where you need to pre-route it before securing the motherboard inside the case. At the back, you've about 3 cm to "tuck" in the cables.

Share this content
Twitter Facebook Reddit WhatsApp Email Print