Corsair H100 review

Cooling 189 Page 8 of 10 Published by

teaser

Noise levels - Sound pressure readings

 

Noise Levels

With a certified dBA meter we measure how many dBAs originate from the PC. It's slightly subjective as there is always noise in the background, from the streets, from the HD, PSU fan, etc so this is by a mile or two not a precise measurement. You could only achieve objective measurement in a sound test chamber. Take this measurement as an indication, not a precise measurement please.

The human hearing system has different sensitivities at different frequencies. This means that the perception of noise is not at all equal at every frequency. Noise with significant measured levels (in dB) at high or low frequencies will not be as annoying as it would be when its energy is concentrated in the middle frequencies. In other words, the measured noise levels in dB will not reflect the actual human perception of the loudness of the noise. That's why we measure the dBA level. A specific circuit is added to the sound level meter to correct its reading in regard to this concept. This reading is the noise level in dBA. The letter A is added to indicate the correction that was made in the measurement. Frequencies below 1kHz and above 6kHz are attenuated, whereas frequencies between 1kHz and 6kHz are amplified by the A weighting.

TYPICAL SOUND LEVELS
Jet takeoff (200 feet) 120 dBA  
Construction Site 110 dBA  Intolerable
Shout (5 feet) 100 dBA  
Heavy truck (50 feet)  90 dBA  Very noisy
Urban street  80 dBA  
Automobile interior  70 dBA  Noisy
Normal conversation (3 feet)  60 dBA  
Office, classroom  50 dBA  Moderate
Living room  40 dBA  
Bedroom at night  30 dBA  Quiet
Broadcast studio  20 dBA  
Rustling leaves  10 dBA  Barely audible

But let's have a peek at noise levels. We take a dBA gun and point it at the working PC and take a distance of 75 CM. The PC again is stressed at 3200 MHz on the CPU with 80% RPM set in the BIOS. These, as such, are noise levels measured under heavy CPU load.

The H100 has three preferences, depending on your needs you can select three RPM modes, silent, normal and high performance. If you don't do anything crazy with the PC, silent mode will be just fine. At that stage you can not hear the LCS kit.

In normal mode you get a notch better cooling, but at the cost of noise. Nothing to worry about, 42 dBA is normal for your average PC.

If you need serious cooling performance, then go for the enthusiast setting. Mind you that it is loud and audible though.

Corsair H100

Share this content
Twitter Facebook Reddit WhatsApp Email Print