Noise levels - Sound pressure readings
Noise Levels
With a certified dBA meter we measure how many dBAs originate from the PC. It's slightly subjective as there is always noise in the background, from the streets, from the HD, PSU fan, etc. so this is by a mile or two not a precise measurement. You could only achieve objective measurement in a sound test chamber. Take this measurement as an indication, not a precise measurement please.
The human hearing system has different sensitivities at different frequencies. This means that the perception of noise is not at all equal at every frequency. Noise with significant measured levels (in dB) at high or low frequencies will not be as annoying as it would be when its energy is concentrated in the middle frequencies. In other words, the measured noise levels in dB will not reflect the actual human perception of the loudness of the noise. That's why we measure the dBA level. A specific circuit is added to the sound level meter to correct its reading in regard to this concept. This reading is the noise level in dBA. The letter A is added to indicate the correction that was made in the measurement. Frequencies below 1kHz and above 6kHz are attenuated, whereas frequencies between 1kHz and 6kHz are amplified by the A weighting.
| TYPICAL SOUND LEVELS | ||
| Jet takeoff (200 feet) | 120 dBA | |
| Construction Site | 110 dBA | Intolerable |
| Shout (5 feet) | 100 dBA | |
| Heavy truck (50 feet) | 90 dBA | Very noisy |
| Urban street | 80 dBA | |
| Automobile interior | 70 dBA | Noisy |
| Normal conversation (3 feet) | 60 dBA | |
| Office, classroom | 50 dBA | Moderate |
| Living room | 40 dBA | |
| Bedroom at night | 30 dBA | Quiet |
| Broadcast studio | 20 dBA | |
| Rustling leaves | 10 dBA | Barely audible |
But let's have a peek at noise levels. We take a dBA gun and point it at the working PC and take a distance of 75 CM.
So, explaining sound (or noise levels) is always difficult, but up-to 40 dBA is considered to be silent. Once you're in the 41~42 dBA range you can hear the product and after 43~44 dBA the product can be considered to be a more noisy cooler.
We now put the processor under 100% load again with the processor under full load for a full wPrime run. Noise pressure is a difficult thing to explain alright.
The results are based on DEFAULT clock frequency and RPM settings (thus NORMAL configuration in the BIOS). In this setup the cooler is silent. If you set it at a higher mode like Turbo (on ASUS motherboards) the product will become noisy under load. Overclocked, as explained and shown on the previous page, the cooler is noisy to loud depending on how much extra voltage you insert.
