BitFenix Shogun chassis review

PC Cases and Modding 228 Page 4 of 10 Published by

teaser

Product Showcase - Exterior

 

28269_img_5914


The Shogun has a bit of a mysterious design, just sitting there you can stare at it for minutes without getting bored. This chassis is reasonably light in weight (14kg). The case is a modest size of 250 x 565 x 525 (mm). Motherboard form factors supported are: E-ATX, ATX, microATX, Mini-ITX. So again, the maximum motherboard size that'll fit is E-ATX and NOT XL-ATX.
  

Img_5916


At the backside we see 7 expansion slots, so dual-slot cards can be set up in Crossfire or SLI mode (2-way). All the way down we see the PSU section. PSU wise, you name it up-to 250mm-  it'll fit as we'll show you later on.
  

Img_5918

At the top the front panel connectivity can be found, including 2 x USB 3.0, 2 x USB 2.0 and HD Audio. Other than that, the usual suspects are here like power and reset buttons. Here also you will find a LED controller which can poreset 6 primary colors and an animated modus. 

Both the top and bottom 'rounded'covers are made from aluminum which give it a nice feel. the front bezel however is plastic. It can be easily removed by pulling it towards you. Then you can access the two installed fans or clean the dust filters at the bezel sides.
 

Img_5919

Share this content
Twitter Facebook Reddit WhatsApp Email Print