Product Showcase - Exterior
The Enso has a bit of a mysterious design, the blacks are not dark black though, it's more dark grey(?) This chassis is reasonably light in weight (7kg). The case is a modest size of 210 x 489 x 454 (mm). Motherboard form factors supported are: ATX, microATX, Mini-ITX. The manual mentions E-ATX up -to 27cm, however, I would not recommend it space and clearances wise.
At the backside, we see 7 expansion slots, so dual-slot cards can be set up in Crossfire or SLI mode (2-way). All the way down we see the PSU section. PSU wise it is a tight fit, up-to 160mm in length will work, but after that, you run out of space. We'll show you that later though. What is nice is that the PSU is covered by a shroud.
At the top, the front panel connectivity can be found, including 2 x USB 3.0 and HD Audio. Other than that, the usual suspects are here like power and reset buttons. Here also you will find a LED controller which can preset 6 primary colors and three animated modes. The LED controller is included, but alternatively, you can hook the lighting up to an Aura SYNC compatible motherboard. Most of the paneling and front bezel is plastic, this does give the Enso a bit of cheap feel.