Be Quiet! Silent Base 802 review

PC Cases and Modding 227 Page 5 of 9 Published by

teaser

Product Showcase


 

Img_1447

 
You can mount very lengthy power supplies in the chassis, so that won't be an issue. The PSU will sit on four pads to ensure that no vibrations/noise passes on to the Silent Base 802's frame. Above the PSU bay are the seven motherboard expansion slots, each protected by an individual, reusable cover held in place by a thumbscrew. 


Img_1453

  

Power supply spacing wise, there is no problem whatsoever as you have close to 29 cm clearance. 


Img_1430

 
Included are two slide rails, slash rubberized feet. You pop them in, and they secure themselves.
  

Img_1431

  

The two feet are rubberized, giving more grip to the surface and again preventing resonating noises from escaping the PC. Ther are pretty atrocious to install tbh, but once done, it's all good. We can see the big mesh for air intake as well, covered by a dust filter.
   

Img_1448

  

You will have noticed the small PCB already. This is your HUB, which connects to the fan controller at the IO location upfront. You may add three more fans, 3-pin, though. 

Share this content
Twitter Facebook Reddit WhatsApp Email Print