ASUS ROG Strix GeForce GTX 1080 Ti Review

Graphics cards 1048 Page 9 of 41 Published by

teaser

Graphics Card Thermal Imaging Measurements (FLIR)

Thermal Imaging Temperature Measurements

A new addition to our reviews will be the inclusion of Forward Looking Infra Red thermal images of hardware. Over the past years we have been trying to figure out what the best possible way is to measure temperatures on hardware. Multiple options are available but the best thing to do is to visualize heat coming from the product or component being tested. The downside of thermal imaging hardware is simple, FLIR camera's with a bit of decent resolution costs up-to 10,000 EUR. Hence we passed on it for a long time. With a thermal imaging camera a special lens focuses the infrared light emitted by all of the objects in view. This focused light is scanned by a phased array of infrared-detector elements. The detector elements create a very detailed temperature pattern called a thermogram. It only takes about one-thirtieth of a second for the detector array to obtain the temperature information to make the thermogram. This information is obtained from several thousand points in the field of view of the detector array. The thermogram created by the detector elements is translated into electric impulses. The impulses are sent to a signal-processing unit, a circuit board with a dedicated chip that translates the information from the elements into data for the display. The signal-processing unit sends the information to the display, where it appears as various colors depending on the intensity of the infrared emission. The combination of all the impulses from all of the elements creates the image. We can seek hotspots on the PCB indicating, for example, GPU but also VRM temperature as well as how heat is distributed throughout a product. We do hope you will enjoy this new technology as it did cost us an arm and a leg to be able to implement it. 


Flir1


 
We can measure pretty accurate temperatures at the GPUs and VRM areas. So once we start to stress the GPU the thermals quickly change. We can measure thermals down to a 10th of a degree, our thermal camera was calibrated in 2016.

  • We reach almost 58 degrees C on M1, the GPU marker at the back-plate, the GPU is blocked.
  • At M2 (Measure Point 3) the rear VRM areathere are ICs located and they run just close to 88 Degrees C. This is very hot.
  • At M5 we are close to the VRM area, at 82 Degrees C we feel there is a lot of heat at the backside.

The thermal image clearly shows that the back-plate is not trapping heat. We've seen closed back-plate designs on the founder edition cards, and such ones are not our favorites, we like to see lots of gaps to vent. So this is okay.
 

Flir3



When we position the thermal camera outwards we can see that the card lights up pretty significantly. The hottest point is the top side of the card where there is some residual heat detected. M1 is the hottest spot at 89 Degrees C, that is on top of the the VRM area. The graphics card 100% stressed in a FireStrike scene 1 loop.
 

Flir2

 
Quite a bit of heat this is exhausted at the top side, at the M1 position we remain close to 90 degrees C, again that is on top of the VRM area. That heat ends up in your PC. The card produces quite a bit of heat under full stress so ventilation inside your PC is a must. The temperature above that VRM area slightly worry me albeit the VRM area is covered with thermal padding and the heatsink.

Share this content
Twitter Facebook Reddit WhatsApp Email Print