ADATA S511 series 60GB SSD review

Memory (DDR4/DDR5) and Storage (SSD/NVMe) 367 Page 5 of 17 Published by

teaser

Product showcase

 

Product showcase

The following images were taken at high-resolution and then cropped and scaled down. The camera used was a Canon 450D 12 MegaPixel.

ADATA S511 Series SSD

And though the photo would make you think otherwise, it's of course a perfect fit for laptops. This SSD would bring a whole lot of performance into that laptop alright, all at low power consumption at 1~2 Watts and virtually no heat.

ADATA S511 Series SSD

And there it is, this is the 2.5" SATA III 120 GB version. You should easily be able to place it somewhere in your chassis. Small and light-weight. This drive chunks out peak read and write speeds over 500 MB/sec, crazy stuff.

You do need to connect it to a proper SATA 3 (6G) controller though, the best ones can be found on the Intel series 6 chipset based products (H67/P67/Z68/X79). Some other motherboards will use an additional controller from JMicron or Marvell, these will all result in lower overall performance.

ADATA S511 Series SSD

When we look at the connectors, we spot the standard power and Serial ATA connectors. This drive is SATA3 compatible, which typically requires a specific SATA3 cable by the way. A proper SATA 6G cable is recommended and should be delivered with your motherboard. We did try, and we never ever had issues with a standard SATA2 cable either.

Share this content
Twitter Facebook Reddit WhatsApp Email Print