OCZ released a new firmware update for their Vertex 4 based SSDs. The new revision 184.108.40.206 solves threefold of things. Normally you can not update the firmware if your SSD is a Windows System drive however you can download this little tool that will allow you to reflash the firmware without any dataloss (make a backup none the less).
If it ain't broke for you, then don't try to fix it.
Improved RAID card compatibility.
Corner case issue where drive would not resume from S3/S4 properly.
Rare issue where some platforms would not respond correctly after a cold boot.
OCZ Vertex 3 Low Profile SSDs - 05/22/2012 09:08 AM
OCZ has recently unveiled a new line of SSDs called the Vertex 3 Low Profile. Coming in 60GB, 120GB, 240GB and 480GB capacities, these slim 2.5-inch SSDs (7mm thick) are equipped with MLC NAND Flash m...
OCZ Vertex 4 1.4 - 05/22/2012 08:56 AM
A short while ago we wrote an article about OCZ Vertex 4 1.4 firmware. Well it's out for grabs. The new update will bring significant performance increases to the product. If you decide to flash the f...
OCZ Vertex 4 SSD revisited with FW 1.4RC review - 05/08/2012 04:52 AM
We revisit the OCZ Vertex 4 256 and 512GB SSD review, this time with Firmware 1.4 which makes the drives much faster. Armed with a new Indilinx Everest 2 controller this SSD is advertised as one of th...