It took a little time but it finally is here, the 5.3.7.0 release, biggest change is the new IO driver, which will give support for both 32 and 64 bit Windows version, I recommend you simply install MBM over your current install, do the reboot and it should all be fine

if your using the MBMstarter.dll with a 3rd party program, there is a new release included, make sure you use that

The Uguru support is also included in this official release, with which -I think- I am the first one with support for this sensor chip outside Abit, a big thank you for that once more to Chunkeun Lee.

All the changes are listed below, and as normal the download can be found here

added:
New IO system driver for 32 and 64 bit
Uguru support (big thank you Chunkeun Lee, Alien & Dejan M).
VIA VT8237 southbridge support
ATI SB300C Southbridge support
ADT7460 support
ADT7463 support
TMP100 support
MAX6657 support
MAX6658 support
MAX6659 support
Winbond W83627HF/ADM ADT7463 Combo
Option to write to the sensor chip (see FAQ forum, Ini entries)
Option to set the Prio lvl (see FAQ forum, Ini entries)
Option to start MBM at 16 colors (see FAQ forum, Switches)
MBM5ST.exe in the misc director (see the readme)

Fixed
SHDN not detected problem
BSOD on Win9X with SMART detection turned on
Value deleted in the Windows Run Key

Changes
After Hybernation MBM will be restarted with the same parameters that is started up with
SiS5595 scanning now only via a Ini file entry
Inno setup 4.2.5 used (reason of the smaller download)
ssAlarm2 in the sharedmemory for voltage will now hold the voltage value that sensor is set at
new version of MBMStarter.dll