The side panel one shall agree with is looking nicely styled, taste differs of course. It's hard to see at the photo but a fan controller is located there as well, it will control the actual side panel 1100 RPM fan located on the inside, let's have a look at that.
Here we can see that fan controller on the inside, just plug in the peripheral / molex connector and you are good to go. Also note that an additional; fan is delivered which you can place at that upper empty spot. Not installed because (we think) that if you have large CPU cooler, the fan could actually block it. So that remains your call to make depending on your CPU cooler choice.
The right side panel is completely closed -- kind stealthy really. Personally I like that very much.
The rear panel -- as you can see it the PSU is required to be installed in the upper compartment of the chassis. Below it a 120-mm fan is installed here which is not PWM controlled and will be connected to you peripheral power / Molex connector, not allowing RPM control and or monitor its speed. You'll spot two grommet holes for liquid cooling solutions. Interesting to see are vented slot covers, they can help improving the computer internal airflow. There is also a small mesh above the expansion slots. Airflow should be plentiful especially with the front side completely meshed combined with the number of active fans.
Zalman ZM-K700M keyboard review We review the Zalman ZM-K700M mechanical keyboard. This Cherry MX mechanical keyboard with Cherry MX red switches comes with a new single color (white) LED animation system. Overall a simple and stri...
Zalman ZM-M240W Stereoscopic monitor review Zalman released a new 24" 3D monitor tagged as ZM-M240W. This Stereoscopic 3D LCD Monitor is at a convenient size of 24" / 60cm allowing you to use it perfectly fine as desktop monitor, and it's not too small to watch a 3D movie on either .. with a supported Full HD monitor resolution at 1920x1080 that is.
Zalman Z7 Plus review We test and review the Zalman Z7 Plus ATX Mid Tower chassis. These cases will cost you roughly 55 EUR / 65 USD for the most expensive PLUS version, yet carry features like pleasing aesthetic design, LED front fan, dust filter protections at the meshes, side fan controller, front panel hidden by a door, rubber feet protecting resonation, CPU Cooler Back Plate Hole is provided for convenient CPU cooler installation.