XFX GeForce 9800 GX2 Black edition review
Posted by Hilbert Hagedoorn on: 06/09/2008 01:00 PM [ 0 comment(s) ]
Power consumption
Alright then, we just installed the card into our test-system and will monitor a couple of pretty important items.
We'll first show you some tests we have done on overall power consumption of the PC. Looking at it from a performance versus wattage point of view the power consumption is not as bad as I expected it to be, yet it is a lot. The card according to our findings will consume close to ~200 Watts all by itself when heavily stressed.
Our test system contains a Core 2 Duo X6800 Extreme Processor, the nForce 680i mainboard, a passive water-cooling solution on the CPU, DVD-rom and WD Raptor drive.
|
|||||||||||
The methodology is simple: have a wattage monitor keeping a close eye on power consumption during our entire test-session. This device will register the maximum wattage pulled from the wall power outlet. You are not looking at the power consumption of the graphics card, but the consumption of the entire PC. We had a total system wattage peak at roughly 375-380 Watts with the 9800 GX2 card installed, which is a lot, but not at all shocking. The new 65nm cores are much more power efficient than the G80 generation. So while power consumption is high, it's not at all higher then the last gen 8800 Ultra product + we have more performance.
So here's my power supply recommendation:
- A single GeForce 9800 GX2 requires you to have a 550 Watt power supply unit at minimum if you use it in a high-end system. That power supply needs to have (in total) at least 35 Amps available on the 12 volts rails.
- A second GeForce 9800 GX2 installed is another ballgame though; on this system it requires you to have a 750 Watt power supply unit at minimum if you use it in a high-end system. That power supply needs to have (in total) at least 45 Amps available on the 12 volts rails.
There are many good PSU's out there, please do have a look at our PSU reviews as we have loads of recommended PSU's for you to check out in there. What would happen if your PSU can't cope with the load?:
- bad 3D performance
- crashing games
- overclocking issues
- spontaneous reset or imminent shutdown of the PC
- freezes during gameplay
- PSU overload can cause it to break down
Noise Levels coming from the graphics card
When graphics cards produce a lot of heat, usually that heat needs to be transported away from the hot core as fast as possible. Often you'll see massive active fan solutions that can indeed get rid of the heat, yet all the fans these days make the PC a noisy son of a gun. I'm doing a little try out today with noise monitoring, so basically the test we do is extremely subjective. We bought a certified dBA meter and will start measuring how many dBA originate from the PC. Why is this subjective you ask? Well, there is always noise in the background, from the streets, from the HD, PSU fan etc etc, so this is by a mile or two not a precise measurement. You could only achieve objective measurement in a sound test chamber.
The human hearing system has different sensitivities at different frequencies. This means that the perception of noise is not at all equal at every frequency. Noise with significant measured levels (in dB) at high or low frequencies will not be as annoying as it would be when its energy is concentrated in the middle frequencies. In other words, the measured noise levels in dB will not reflect the actual human perception of the loudness of the noise. That's why we measure the dBa level. A specific circuit is added to the sound level meter to correct its reading in regard to this concept. This reading is the noise level in dBA. The letter A is added to indicate the correction that was made in the measurement. Frequencies below 1kHz and above 6kHz are attenuated, where as frequencies between 1kHz and 6kHz are amplified by the A weighting.
|
|
|||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||
Not too bad, the reference cooler though you can hear yet remains silent. We measure roughly 40 DBa from the (entire) test system. The low noise design definitely works fine. This is in idle though, meaning the graphics cores are hardly doing anything at all and do not create a lot of heat and thus ventilation.
When we start to stress and heat up the GPU cores the RPM of the fans will increase, still not bad bad but our results end at a 45 dBa, which is noticeable, but not at all annoying. The product has two embedded GPUs and this means there's a double amount of heat to get rid of.
XFX GeForce 9800 GX2 core temperatures
Let's have a look at the temperatures these single slot design coolers produce. As always we measured at a room temperature of 21-22 Degrees C.
|
|
||
![]() |
||
Twice the components also means twice the heat created, now the cooler does a really good job, yet that's a lot of heat to push out.
In idle you'll notice that this overclocked product is already quite warm, expect a temperature of 65 Degrees C when the GPUs idle (desktop mode) and during gaming when heat builds up, heavily stressed the GPU core temperature rose towards roughly 75 Degrees C. Not too worrying, yet be aware of he fact that you now have two GPU's at that temperature .. and twice the heat build-up that the graphics card needs to ditch somehow.
As a result the outside chassis of the cooler will get very hot. Unfortunately most of the heat is exhausted in the PC due to the dual-slow cooler design that exhausts heat on the top of the card.
I'm not really thrilled about this to be honest, a lot of heat is being disposed and likely can become an issue in lesser ventilated systems. So please just make very sure your PC innards are very well ventilated and that you have a steady inward flow of cool (outside the PC) air. Very important !
A review on the XFX Black edition GeForce 9800 GTX, after reading some of you guys will probably will run to the store .. as the XFX XXX and Black editions obviously have fallen in price after AMDs Radeon 4850 launch.
XFX GeForce 9800 GX2 Black edition review
King of pre-overclocked products has to be XFX, their speed-bin of releasing OCed products is exceedingly fast. I do not think that there is an XFX product out there that is not available as a triple X edition or other series name slapped on top of it. Today will be no different, we received XFXes top of the shelf product, the GeForce 9800 GX2, the cool thing is that this is the new mystified named 'Black edition' series of cards, meaning it comes with a nice pre-overclock and an lovely game bundle.
XFX GeForce 9600 GT XXX 512MB review
A review on that XXX rated version of the GeForce 9600 GT. Hey, only XFX can implement such a name for you. XFX have a "way" of communication and getting attention. They quite honestly deliver really impressive products. Today's tested product is no different.
XFX GeForce 8800 GTS 320 MB Fatal1ty review
The Fata1ty Geforce 8800 GTS 320MB graphics card comes with it's GPU core pre-overclocked at 650 MHz and it's 320 MB memory clocked at (2x) 999 MHz. If that isn't rather radical, the Shader domain inside that graphics processor is clocked at a lovely 1620 MHz. Now if that does mean jack to you, these are the reference specs a 320 model normally has: 500 MHz core, 2x 800 MHz memory and a shader domain clock of 1200 MHz. Can you already sniff the performance increase ? That's like bacon on your eggs man.

