As most of you know, with most videocards you can apply a simple series of tricks to boost the overall performance a little. You can do this at two levels, namely tweaking by enabling registry or BIOS hacks, or very simply tamper with Image Quality. And then there is overclocking, which will give you the best possible results by far.
What do we need? One of the best tool for overclocking NVIDIA and ATI videocards is our own Rivatuner that you can download here. If you own an ATI or NVIDIA graphics card then the manufacturer actually has some very nice built in options for you that can be found in the display driver properties. Based on Rivatuner you can alternatively use MSI AfterBurner which will work with 90% of the graphics cards out there. We can recommend it alot, download here.
Where should we go? Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.
More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.
All in all... do it at your own risk.
Core Clock: 675MHz
Core Clock: 819MHz
Core Clock: 920MHz
Shader Clock: 1350Hz
Shader Clock: 1840Hz
Memory Clock: 3600MHz
Memory Clock: 4208 MHz
Now we left fan RPM control at default in all circumstances. We reached a very decent overclock guaranteeing better results. We tweaked GPU voltage a little with AfterBurner, and set it to 1.087 Volts. Obviously if you like to give it a go grab AfterBurner and download here, the VRM control is fully supported.
With the overclock our temperature now rises to roughly 80 degrees C under load. DBa levels rose maybe to 44 DBa and power consumption went up from 342 Watt towards 385 Watt. Let's re-check some numbers shall we?
3DMark Vantage - setup in Performance mode
Another massive gain in performance alright. BTW without added voltage tweaking anything higher than give or take 860 MHz should become an issue. Still look at the performance increase thanks to the overclock. And please do have a peek at reference performance.
SOC model with COD: Modern Warfare 2, maxed out image quality settings as before with 4xAA 16xAF
PoV GeForce FX 5500 Review When I first asked NVIDIA about the 5500 they seemed utterly surprised and asked why I was reviewing a 5500. Hey it's a big market and NVIDIA sells more low and mid end products then high-end. So why not ?