OCZ Vertex 2 SSD review
Posted by Hilbert Hagedoorn on: 05/02/2010 01:00 PM [ 0 comment(s) ]
HD Tach 22.214.171.124
HD Tach is a physical performance hard drive test that uses a special kernel mode VXD to get maximum accuracy by bypassing the file system.
The HD Tach sequential read test is a little bit different from other benchmarks. Most benchmarks create a file on the hard drive and test within that file. The problem is that modern hard drives use a zone bit recording technique that allows different read speeds depending on where the data is located. Data on the outside of the drive is much faster than data recorded on the inside.
With this test we NEVER reach advertised speeds. The Vertex 2 is pushing 230MB/sec and that makes it slightly slower than the competition.
When we look at write performance we still get close to 202 MB/sec in this test, that's leading perf.
In addition to sequential read performance, HD Tach tests the drive's random access time. Random access is the true measure of seek speed. Many drives advertise sub 10 millisecond seek speeds, but seek speeds are misleading. Also again, without a physical head that needs moving around, the SSDs are just so fast as they have no mechanical moving parts. Here obviously .. the smaller number is better, 0.1 ms (!).
In this article we test, benchmark and review the all new OCZ Vertex 450 SSD. Armed with the new Indilinx Barefoot 3 controller this is the fifth incarnation of the popular OCZ Vertex series. Will it be as fast and competitive as it's predecessors ? Well let's see and find out shall we ?
OCZ Vertex 3.20 SSD review
In this article we test, benchmark and review the OCZ Vertex 3.20 SSD. What a great and fast piece of technology this is. An 20nm NAND flash SSD that is speedy and actually amongst the the rest of the devices tested, but also mroe affordable. Head on over into the review.
OCZ Vertex 4 SSD review with 1.5 firmware
We retest the OCZ Vertex 4 SSD yet now with 1.5 firmware update. , again bringing more performance towards the Vertex 4 series of SSDs. And albeit the difference is not as big as the 1.4 release was, it certainly makes a difference as this article will show you.
OCZ Vertex 4 SSD revisited with FW 1.4RC review
We revisit the OCZ Vertex 4 256 and 512GB SSD review, this time with Firmware 1.4 which makes the drives much faster. Armed with a new Indilinx Everest 2 controller this SSD is advertised as one of the fastest on the block with screaming IOPs performance. Lets have a look shall we ?