Installation of any of the AMD Radeon cards is really easy. Once the card is seated into the PC make sure you hook up the monitor and of course any external power connectors like 6 and/or 8-pin PEG power connectors. Preferably get yourself a power supply that has these PCIe PEG connectors native (converting them from a Molex Peripheral connector anno 2012 we feel is a no-go).
Once done, we boot into Windows, install the latest ATI Catalyst drivers and after a reboot all should be working. No further configuration is required or needed unless you like to tweak the settings, for which you can open the Catalyst Control Center.
Let's have a look at how much power draw we measure with this graphics card installed.
The methodology: We have a device constantly monitoring the power draw from the PC. We simply stress the GPU, not the processor. The before and after wattage will tell us roughly how much power a graphics card is consuming under load.
Note: there has been a lot of discussion using FurMark as a stress test to measure power load. Furmark is so malicious on the GPU that it does not represent an objective power draw compared to really hefty gaming. If we take a very-harsh-on-the-GPU gaming title, then measure power consumption and then compare the very same with Furmark, the power consumption can be 50 to 100W higher on a high-end graphics card solely because of FurMark.
We decided to move away from Furmark in early 2011 and are now using a game like application which stresses the GPU 100% yet is much more representable of power consumption and heat levels coming from the GPU. We however are not disclosing what application that is as we do not want AMD/ATI/NVIDIA to "optimize & monitor" our stress test whatsoever, for our objective reasons of course.
Our test system is based on a power hungry Core i7 965 / X58 system. This setup is overclocked to 3.75 GHz. Next to that we have energy saving functions disabled for this motherboard and processor (to ensure consistent benchmark results). On average we are using roughly 50 to 100 Watts more than a standard PC due to higher CPU clock settings, water-cooling, additional cold cathode lights etc.
We'll be calculating the GPU power consumption here, not the total PC power consumption.
Measured power consumption HIS R7750
System in IDLE = 152W
System Wattage with GPU in FULL Stress = 185W
Difference (GPU load) = 33W
Add average IDLE wattage ~10W
Subjective obtained GPU power consumption = ~ 43 Watts
Mind you, the system wattage is measured at the wall socket. We estimate and calculate here based on four hours GPU intensive gaming per day for 5 days a week with this card.
Above, a chart of relative power consumption. Again, the Wattage shown is the card(s) with the GPU stressed 100%, showing only the peak GPU power draw, not the power consumption of the entire PC and not the average gaming power consumption.
Here is Guru3D's power supply recommendation:
Radeon HD 7750 - On your average system the card requires you to have a 450 Watt power supply unit.
If you are going to overclock the GPU or processor, then we do recommend you purchase something with some more stamina.
There are many good PSUs out there, please do have a look at our many PSU reviews as we have loads of recommended PSUs for you to check out in there. What would happen if your PSU can't cope with the load:
bad 3D performance
spontaneous reset or imminent shutdown of the PC
freezing during gameplay
PSU overload can cause it to break down
Let's move to the next page where we'll look into GPU heat levels and noise levels coming from the graphics cards.
HIS Radeon R9-290X Hybrid ICEQ review In this review we will benchmark and test HIS Radeon R9-290X Hybrid ICEQ edition. The card uses liquid cooling for the GPU that runs towards a 120mm radiator. On the card itself there still is a sma...
HIS Radeon R7-260X iCooler review Today we'll review the AMD Radeon R7-260X, a brother of the 260. The Radeon R7 260X is fitted with a Curacao XT core which has cut down specifications with a total of 896 Stream processors, a compu...
HIS Radeon R9-280 IceQ X2 OC review In this review we look at the Radeon R9-280 IceQ X2 OC review from HIS. R9-280 You read that right, anyone remember the Radeon HD 7950 ? Armed with a customized PCB and their top model IceQ coolers ...
HIS Radeon R9-290X review In this review we test the HIS Radeon R9-290X. The product is based on the reference design of the original Radeon R9-290X. These cards are little beasts. As such this in-depth review will cover the V...