As most of you know, with most videocards you can apply a simple series of tricks to boost the overall performance a little. You can do this at two levels, namely tweaking by enabling registry or BIOS hacks, or very simply to tamper with Image Quality. And then there is overclocking, which will give you the best possible results by far.
What do we need? One of the best tools for overclocking NVIDIA and ATI videocards is our own AfterBurner which will work with 90% of the graphics cards out there. We can really recommend it, download here.
Where should we go? Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners, to not increase the frequency any higher than 5% on the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest that you don't increase the frequency any higher than 30 to 50 MHz.
More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it.
All in all... do it at your own risk.
Core Clock: 900MHz
Core Clock: 950MHz
Core Clock: 1102MHz
Shader Clock: 1800MHz
Shader Clock: 2204MHz
Memory Clock: 4100MHz
Memory Clock: 4626MHz
Now we left fan control at default, thus self regulating and during the overclock it did not at all become noisy.
This is a fully supported MSI card with AfterBurner, so we gave the GPU some extra voltage. We set it at 1.15v and then where able to take the clock frequency of the graphics core towards 1102 MHz! Memory overclocking was performing good as well as we bumped it up towards 4626 MHz (effective data-rate).
Without voltage tweaking you can expect to reach roughly 1 GHz on the core by the way.
Here's what that significant overclock does towards overall game performance.
Above Call of Duty: Modern Warfare 2, maxed out image quality settings as before with 4xAA 16xAF
Above Battlefield Bad Company 2, maxed out image quality settings as before with 8xAA 16xAF
Nvidia GeForce GTX 970 and 980 reference review A while ago Nvidia launched the GeForce GTX Titan Black which we review. We never tested it as it was supposed to be a professional series and targeted card. Nvidia's Board partners however are slowl...
Gigabyte GeForce GTX 980 G1 Gaming review After the reference review we will now review the Gigabyte GeForce GTX 980 G1 SOC gaming graphics card. Armed with a totally custom design, two 8-pin power feeds and an all new WindForce based cooler ...
Gigabyte GeForce GTX 970 G1 Gaming review Next to the flagship product we also test the more budget Gigabyte GeForce GTX 970 G1 SOC gaming graphics card. The product does not vary much from that 980 other then a chunk of performance. This car...
MSI GeForce GTX 970 Gaming OC review We review the new MSI GeForce GTX 970 Gaming OC edition. This affordable model comes with the new TwinFrozr V cooler. The GM204-200 chip is smacked onto a custom PCB surrounded with Military class co...